/

12 Gauge (Alliant Data) : 3 1/2" Remington Plastic SP (Steel Shot Only)
Warning! Notes: Reloading steel shotshells requires strict adherence to Alliant published reloading specifications. The reloading specifications provided were derived through the use of controlled laboratory conditions. While reloading steel shotshells, the reloader must adhere precisely to all the components, without exception, set forth in the load data and specifications. Alliant recommends that both powder charge and shot charge be individually weighed to insure compliance to the load data. Steel shotshells should only be used in well maintained firearms that are designed to shoot steel shot loads. Alliant recommends that commercially available shotshell sealant be applied to both the primer and crimp areas to prevent moisture penetration. (Alliant Reloaders' Guide)
Be Alert: Publisher cannot be responsible for errors in published load data.
Shot Powder Type Manufacturer Charge Primer Wad Velocity (FPS)
1 1/4 ounces STEEL Alliant Subscribe Federal 209A Ballistic Products mm12312 1,615
Remarks: approx. pressure: 13,300; add three 12-gauge, 1/8 inch felt spacers to the inside bottom of the shot cup
1 1/4 ounces STEEL Alliant Subscribe Federal 209A R.S. SAM 1 1,595
Remarks: approx. pressure: 13,100; add three 12-gauge, 1/8 inch felt spacers to the inside bottom of the shot cup
1 3/8 ounces STEEL Alliant Subscribe Federal 209A Ballistic Products mm12312 1,430
Remarks: approx. pressure: 12,800; add two 12-gauge, 1/8 inch felt spacers to the inside bottom of the shot cup
1 1/2 ounces STEEL Alliant Subscribe Federal 209A R.S. SAM 1 1,330
Remarks: approx. pressure: 13,000; add two 12-gauge, 1/8 inch felt spacers to the inside bottom of the shot cup
1 1/2 ounces STEEL Alliant Subscribe Federal 209A Ballistic Products mm12312 1,305
Remarks: approx. pressure: 13,000; add two 12-gauge, 1/8 inch felt spacers to the inside bottom of the shot cup
1 3/8 ounces STEEL Alliant Subscribe Federal 209A R.S. SAM 1 1,430
Remarks: approx. pressure: 12,800; add three 12-gauge, 1/8 inch felt spacers to the inside bottom of the shot cup