/

---

12 Gauge (Alliant Data) : 2 3/4" Federal Gold Medal (Steel Shot Only)

Warning! Notes: Reloading steel shotshells requires strict adherence to Alliant published reloading specifications. The reloading specifications provided were derived through the use of controlled laboratory conditions. While reloading steel shotshells, the reloader must adhere precisely to all the components, without exception, set forth in the load data and specifications. Alliant recommends that both powder charge and shot charge be individually weighed to insure compliance to the load data. Steel shotshells should only be used in well maintained firearms that are designed to shoot steel shot loads. Alliant recommends that commercially available shotshell sealant be applied to both the primer and crimp areas to prevent moisture penetration. (Alliant Reloaders' Guide)

Be Alert: Publisher cannot be responsible for errors in published load data.

Shot	Powder Type	Manufacturer	Charge	Primer	Wad	Velocity (FPS)
7/8 ounce	STEEL	Alliant	Subscribe	Federal 209A	R.S. SAM 1	1,700
Remarks: approx. pressure: 7,800; add two 12-gauge, 1/8 inch felt spacers to the inside bottom of the shot cup
7/8 ounce	STEEL	Alliant	Subscribe	Federal 209A	Ballistic Products mm12234	1,765
Remarks: approx. pressure: 9,000; add one 12 gauge, 1/8 inch felt spacer to the inside bottom of the shot cup
1 ounce	STEEL	Alliant	Subscribe	Federal 209A	R.S. SAM 1	1,520
Remarks: approx. pressure: 9,200
1 ounce	STEEL	Alliant	Subscribe	Federal 209A	Ballistic Products mm12234	1,480
Remarks: approx. pressure: 9,500; add one 12-gauge, 1/8 inch felt spacer to the inside bottom of the shot cup
1 ounce	STEEL	Alliant	Subscribe	Federal 209A	P.R. TUFW12	1,500
Remarks: approx. pressure: 8,000; add one 12-gauge, 1/8 inch felt spacer to the inside bottom of the shot cup
1 1/8 ounces	STEEL	Alliant	Subscribe	Federal 209A	R.S. SAM 1	1,380
Remarks: approx. pressure: 9,000
1 1/8 ounces	STEEL	Alliant	Subscribe	Federal 209A	P.R. TUFW12	1,425
Remarks: approx. pressure: 9,600